COLOUR: Translucent
VOLUME:
High Performance Low Modulus Silicone Sealant
Suitable For
SiegelSeal N08+ is engineered to give lifelong performance in demanding applications such as control and expansion joints, façade caulking, perimeter sealing, hardstand and armour joints and other sealing applications.
Instructions: Remove a sausage of SiegelSeal N08+ from the carton and place in the sausage gun. Holding the sausage gun upright, use side cutter or a knife to cute the metal crimp off one end of the sausage. Cut a nozzle down to the desired nozzle diameter and place in the nozzle clasp and screw on the end of the gun. Ensure the surface is correctly prepared or primed. Pump the silicone as required. SiegelSeal N08+ must be tooled with light pressure within 5 minutes post-application to spread the material against the joint surface for a professional finish. For but joints, SiegelSeal N08+ should be applied to a joint of at least 5x5mm, and bigger joints have a width to depth ratio of about 2:1. SiegelSeal N08+ in its uncured state can be cleaned with solvent. When cured it is very difficult to remove.
| Sealant Type | Neutral Oxime Cure Silicone | |
| Colour | Colours | |
| Density | 1.34 ± 0.03 g/ml | ASTM D792 |
| Sheen | Matte Colours | |
| Shore Hardness A | 22 | ASTM D2240 |
| Tensile Strength | 1.5 N/mm² | ASTM D412 |
| Application Temperature | +5°c to +50°c | |
| Temperature Resistance | -60°c to +180°c | |
| Smoke Point | 220°c +/- | |
| Low VOC Compliance | Yes | GBCA Greenstar Compliant |
| VOC Content | 25 grams / litre | ASTM D3960-05 |
| Curing Speed | 3mm / 24 hours | (23°c and 50% R.H) |
| Movement Capacity | -50% / +100% | ASTM C719 |
| Elongation at Break | ≥800% | ASTM D412 |
| Sagging | 0mm | ISO 7389 |
| Skin Formation | 5 -10 minutes | (23°c and 50% R.H) |
Access Technical Data Sheets, Safety Data Sheets and expert recommendations from our technical team.
Speak to Technical Team