COLOUR: Translucent
VOLUME:
High Performance Neutral Oxime Cure Silicone Sealant
Suitable For
SiegelSeal N05+ is engineered to give lifelong performance in a wide range of professional applications such as glazing, caulking, weathersealing, roofing, guttering, HVAC, sheetmetal and demanding UV exposure applications.
Instructions: Remove a cartridge of SiegelSeal N05+ from the carton and use a side cutter or a knife to cut the tip of the cartridge. Cut a nozzle down to the desired nozzle diameter and screw the onto the end of the cartridge. Place the cartridge in the cartridge gun. Ensure the surface is correctly prepared or primed. Pump the silicone as required. SiegelSeal N05+ must be tooled with light pressure within 5 minutes post-application to spread the material against the joint surface for a professional finish. For but joints, SiegelSeal N05+ should be applied to a joint of at least 5x5mm, and bigger joints have a width to depth ratio of about 2:1. SiegelSeal N05+ in its uncured state can be cleaned with solvent. When cured it is very difficult to remove.
| Sealant Type | Neutral Oxime Cure Silicone | |
| Colour | Translucent & Colours | |
| Density | 1.35 ± 0.03 g/ml | ASTM D792 |
| Sheen | Low Sheen Colours | |
| Shore Hardness A | 25 | ASTM C661 |
| Tensile Strength | 1.3 N/mm² | ASTM D412 |
| Application Temperature | +5°c to +50°c | |
| Temperature Resistance | -60°c to +180°c | |
| Smoke Point | 220°c +/- | |
| Low VOC Compliance | Yes | GBCA Greenstar Compliant |
| VOC Content | 39 grams / litre | ASTM D3960-05 |
| Curing Speed | 3mm / 24 hours | (23°c and 50% R.H) |
| Movement Capacity | 35% ± | ASTM C719 |
| Elongation at Break | ≥500% | ASTM D412 |
| Sagging | 0mm | ISO 7389 |
| Skin Formation | 5 -10 minutes | (23°c and 50% R.H) |
Access Technical Data Sheets, Safety Data Sheets and expert recommendations from our technical team.
Speak to Technical Team